NeuroSurgSim/Management

__NOTITLE__

Home Project Management TCons/Meetings Backlog Conferences Sprints Tools Instructions Building Sofa Development Workflow Report Problems Bugs Contact Us

Regular Meetings 2013-12-09 On the agenda: 1. Status Report, check on the status for components. 2. Repository and review software process practices, make sure everyone can build and run SOFA 3. Set specific deadlines for delivering of code so we can integrate before the deadline for the first alpha release (see document for Goals and Deadlines) as we discussed at the kickoff meeting. The main goal of this project is to develop an interactive simulator for neurosurgical procedures involving vasculature using the SOFA framework. The development consists of anatomical modeling and volumetric meshing of vascular structures, combining a FEM biomechanical modeling with fluid simulation; coupling collision detection and response with haptic feedback; and integrating GPU-based implementations for real-time simulation. This Phase II proposal is a partnership between Kitware Inc.; the Center for Modeling, Simulation and Imaging in Medicine (CeMSIM) at Rensselaer Polytechnic Institute (RPI); the Departments of Computer Science and Neurosurgery at the University of North Carolina (UNC); and Old Dominion University (ODU). Kick-off Meeting Tentative Schedule Date: November 20, 2013 @ 3PM to 5PM Place: Kitware Office Suite G-4 101 East Weaver St Carrboro, North Carolina 27510 USA Direction: We are located on the 3rd floor above Weaver St Market in Carrboro. You can enter the building from the east end that is nearest the parking lot that is shared with restaurants (Southern Rail etc...) in the area. Our office is at the far end of the hall from the elevators. Time Description 3:00PM Welcome and team introduction (Andinet Enquobahrie, Kitware) 3:05PM Clinical focus: Surgical treatment of arteriovenous malformation (AVM) (Deanna Sasaki-Adams, UNC-Neurosurgery) 3:20PM Vascular modeling (Stephen Aylward, Kitware) 3:30PM Collision detection, responses and haptics real-time simulation (Dinesh Manocha, UNC-Computer Science) 3:40PM Mesh generation (Nikos Chrisochoides (ODU) 3:50PM Biomechanical engine (Ganesh Sankaranarayanan & Venkata S Arikatla , RPI ) 4:00PM Validation study design (Bing Wu, ASU) 4:10PM Simulation framework ( Ricardo Ortiz, Kitware ) 4:20PM Project planning discussion Year 1 milestones Project coordination (regular tcons, Wiki, etc..) Data transfer IRB Software process: (implementation, repository) Targets ( publications, software demos, conferences ) 5:00 PM Wrap-up 6:00PM Dinner: Crooks corner